The short answer
Most North Bay Village homes are heated by a heat pump, electric heat strips, or both, and these parts can fail after sitting unused for months. AirVantage Heating & Cooling diagnoses and repairs heat pumps and heat strips, from stuck reversing valves to failed heat strips and sequencers.
In North Bay Village, you may only need heat on a few cool nights each year. That's why heating problems often show up at a bad moment. A system that has run in cooling mode since last winter gets switched to heat during a cool snap, and instead of warmth you get a burning smell, cold air, or a tripped breaker. AirVantage Heating & Cooling repairs the heat pumps and electric heat strips that warm most homes and condos here. We're based in Miami, about 8 miles southwest of North Bay Village. We also serve nearby Miami Beach, North Miami, Opa-locka, Miami Springs, and Hialeah.
How Homes in North Bay Village Are Heated
Most homes here don't have a furnace. Heat usually comes from one of two sources. The first is a heat pump, which is the same outdoor unit that cools your home in summer, running in reverse. The second is electric heat strips, which are resistance coils inside the indoor air handler. Many systems have both. The heat pump does most of the work, and the strips act as backup or emergency heat. Knowing which setup you have matters, because the same symptom can point to different parts.
Like neighboring Miami Beach, this area has a wet season from May through October and a sunnier, less humid stretch from November through April. Air conditioning runs most of the year, and heating mode gets used only briefly. That means the parts tied to heating, such as the reversing valve, heat strips, sequencers, and defrost controls, can sit untouched for many months before you need them.
Common Heating Problems We Repair
These are the issues North Bay Village homeowners most often call about once the weather turns cool:
- Cold or lukewarm air in heat mode: often a stuck reversing valve, an incorrect thermostat setting, or low refrigerant.
- A burning or dusty smell the first time heat runs: usually dust burning off the heat strips, which should fade within a short time. A smell that lingers or smells electrical needs a technician.
- A breaker that trips when the heat comes on: commonly a failed heat strip element, a bad sequencer, or a wiring fault.
- An "aux heat" or "emergency heat" indicator that stays on: a sign the heat pump isn't carrying the load and the strips are doing all the work.
- The outdoor unit runs, but the house doesn't warm up, or the unit gets stuck in defrost.
- The thermostat calls for heat, but nothing happens: often wiring, a control board, or thermostat configuration.
Salt Air, Storms, and Your Heating System
North Bay Village sits in Biscayne Bay, so outdoor units are exposed to salty, humid air all year. Over time this corrodes coils, electrical connections, and contactors. A part that still works for cooling can fail under the different demands of heating mode.
The Atlantic hurricane season runs from June 1 to November 30. Power surges, wind-driven debris, and standing water can damage an outdoor unit or control board, and some of that damage only shows up when you switch to heat for the first time. If your equipment sat in floodwater, don't run it until it has been inspected.
What to Expect From a Heating Repair Visit
We start by confirming the thermostat is set up correctly for your type of system. Next, we run the heat pump in heating mode and check the reversing valve, refrigerant pressures, and defrost operation. Inside, we inspect the heat strips, sequencers, limit switches, and wiring in the air handler. Before we do any work, we explain what we found and what your options are.
Sometimes repair isn't the most sensible choice, especially for an older system with repeated failures. If you decide to replace it, Florida Power & Light's Residential HVAC program offers rebates on qualifying high-efficiency heat pumps through participating contractors at the time of installation. We confirm the current terms before including them in a quote. Note that the federal Energy Efficient Home Improvement Credit only covered qualifying heat pumps placed in service before December 31, 2025, so it is no longer available for new installations.
Quick Checks Before You Call
A few simple steps can rule out easy fixes:
- Make sure the thermostat is set to Heat and the set temperature is above the current room temperature.
- Replace the thermostat batteries if it uses them.
- Check the breakers for both the indoor air handler and the outdoor unit. If one has tripped, reset it once. If it trips again, leave it off and call us.
- Look at the air filter. A clogged filter can cause heat strips to overheat and shut off.
- Confirm that supply vents and return grilles are open and not blocked by furniture.
More services in North Bay Village
- AC Repair in North Bay Village
- Heat Pump Installation in North Bay Village
- AC Installation in North Bay Village
- Furnace Repair in North Bay Village
